Case4-Pi  (Model B version)        
9 10 11 3
Equipment Needed (1) Case4-Pi kit  (B version) (2) Ball point pen         (preferable thin point type) (3) Clear adhesive tape       (12mm wide is easiest to use)   (4) Rule    (30cm long is ideal) (5) Cutting board  (to protect table)       (or work on used paper) (6) Knife  or use the pen point to    remove the  ‘push out parts’      
This is how it will look when finished. (without a Case4-Lid) 
Collect Case4-Pi  B version sheet and the nut and bolt needed later. 
Prepare to remove the ‘push out parts’. Use knife or pen to help remove the ‘pips’ holding it in place. 
Remove the ‘push out parts’ 
Score along the bend lines. Use the marks provided to line up the rule before scoring.
Fold the lines just scored right over.
Bevel corner edges (the edges that meet up when the box is folded up)
Finish taping corners so it looks like this.  
Bolt Raspberry Pi in the Case4-Pi (the pen points to the ‘nut and bolt’  position)   
You are now ready to use it. Start by adding your SD card.  
Making instructions for the Case4-Pi  to fit Raspberry Pi model B only 
Tape Tape  dispenser Tape Tape Tape
Start taping corners.  on one side, ensure corners meet well. Ask an adult helper if needed.
Images taken from our YouTube video 
Copyright © Stewart Dunn 2013 onwards
Pi-School TLBRC